- We've send you an E-mail with your account information
Incl. VAT: 505.00 EUR
The perfect tool for trouble shooting, start-up and quality control of low voltage AC induction motors. Trouble Shooting: Know in a few minutes what the problem is: connections or cable, electrical or mechanical, coil, internal fault or ground fault. Start-up: Make sure electrical motors, connections and cables are working in top condition. Quality Assurance. Test new and stored spare motors. Test repaired motors to find irregularities or a possible faulty repair with different wire sizes, or wiring configuration. Revolutionary tester goes far beyond what you can see with only a Meg-OHM-Meter! Safe: De-energized testing Easy: As easy to use as any Megohm-meter or multimeter Light: 1 pound, hand-held Batteries: They last for up to 10 hours of testing Best Value: Costs less than a good Meg-Ohm-Meter offering a quick return on your investment What you will find with the MOTOR GENIE: Internal winding faults: Turn-to-turn, coil to coil, open windings and continuity Contaminated windings: Grease, dirt and liquids, corrosion Bad cables or connections: Broken or damaged, corroded or loose connections Insulation to ground faults: Choose 500 or 1000 volt test, read to 500MΩ Phase unbalance: Z-unbalance = Higher electric bills and shorter motor life The instrument is delivered ready to use incl. rechargeable battery, mains supply/charger, test leads, crocodile clips and manual on CD.
Incl. VAT: 1,493.75 EUR
The perfect tool for trouble shooting, start-up & quality control of AC/DC electric motors, Generators or Transformers. The hand-held ALL-TEST PRO 31™ (AT31™) is an excellent trouble-shooting tool that will test a wide variety of motors and transformers. The AT31™ will find winding faults such as turn to turn and coil to coil, along with grounded windings. The rotor test helps you detect rotor problems such as broken rotor bars and eccentricity. The AT31™ will measure impedance (Z), phase angle (Fi), current/frequency response (I/F), insulation to ground resistance (500V or 1000V and measure to 500 meg-ohm), will perform a quick pass/fail rotor test (by turning the motor shaft), and will measure EMI. Measurement results can be entered into our optional Condition Calculator software. The software will perform an unbalance calculation and report back on the condition of the winding, plus will allow the results to be stored and printed. However, the software does not perform data trending. AT31™ testing range is dependent upon motor, transformer, or generator design, but the AT31™ has successfully tested AC motors of hundreds of horsepower in size. The instrument is delivered ready to use in bag incl. rechargeable battery, mains supply/charger, test leads and crocodile clips, software and manual on CD.
Incl. VAT: 3,196.25 EUR
© 2016 Elma Instruments. All Rights Reserved.
Sign up for our exciting newsletter and receive offers and news early.
All you need to do is to fill in the below form.